AudioRoundTable.com: Speaker » Mid to Woofer crossover frequency selection

Home » Audio » Speaker » Mid to Woofer crossover frequency selection

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Mid to Woofer crossover frequency selection [message #24511 is a reply to message #24510]

Sat, 01 November 2008 11:38

Goldy
Messages: 6
Registered: May 2009

Esquire

Bill,
Thanks for your reply.
c-t-c is 3" (not 3" between mid drivers).
Are there any drawbacks of crossimg this high( or is it an advantage). Later, If I have to add surround channels, I would go for a smaller surround array with lesser number of mid drivers resulting in about 24" gap between the lowest mid driver and the woofer. Is 300 HZ crossover still fine? Will it not cause any audible detrimental effetcs?

Report message to a moderator

[Message index]

		Mid to Woofer crossover frequency selection By: goldyrathore on Fri, 31 October 2008 10:59
		Re: Mid to Woofer crossover frequency selection By: Bill Wassilak on Fri, 31 October 2008 21:57
		Re: Mid to Woofer crossover frequency selection By: Goldy on Sat, 01 November 2008 11:38
		Re: Mid to Woofer crossover frequency selection By: Marlboro on Sun, 02 November 2008 17:48
		Re: Mid to Woofer crossover frequency selection By: goldyrathore on Sun, 30 November 2008 04:37
		Re: Mid to Woofer crossover frequency selection By: goldyrathore on Sat, 13 June 2009 07:24
		Re: Mid to Woofer crossover frequency selection By: Wayne Parham on Sat, 13 June 2009 11:17
		Re: Mid to Woofer crossover frequency selection By: Eric J on Fri, 07 August 2009 21:40
		Re: Mid to Woofer crossover frequency selection By: Eric J on Fri, 07 August 2009 21:38

Previous Topic:	pipedreams 21s cost to build?
Next Topic:	Salvaging my misguided array Help Fred

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 21:10:33 CST 2024