AudioRoundTable.com: Speaker

Home » Audio » Speaker » Array position

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

The 6-1/2s aren't on SC's site; they're left from SC's speaker-system-building days. [message #23332 is a reply to message #23331]

Tue, 05 December 2006 12:27

jeffreybehr
Messages: 19
Registered: May 2009

Chancellor

They're made by Peerless (I believe) and use a plasticized-paper cone; 4-Ohm impedance; sensitivity about 90dB. Jeff Glowacki has some specs on them; call him at 940/689-9800.

They're $10 each; minimum quantity is one carton of 24 drivers. I expect they're down to single-digit number of cartons left.

Report message to a moderator

[Message index]

		Array position By: JP Haggar on Fri, 24 November 2006 00:01
		If the bass/MR drivers are outside, the soundstage/image will sound wider. By: jeffreybehr on Fri, 24 November 2006 09:40
		Re: If the bass/MR drivers are outside, the soundstage/image will sound wider. By: JP Haggar on Fri, 24 November 2006 10:50
		To post an image in a note, 1st post the image on a foto-sharing site... By: jeffreybehr on Fri, 24 November 2006 11:12
		Re: SC 6 1/2" drivers? By: Jim Holtz on Tue, 05 December 2006 09:50
		The 6-1/2s aren't on SC's site; they're left from SC's speaker-system-building days. By: jeffreybehr on Tue, 05 December 2006 12:27
		Re: The 6-1/2s aren't on SC's site; they're left from SC's speaker-system-building days. By: Jim Holtz on Tue, 05 December 2006 19:46
		Re: If the bass/MR drivers are outside, the soundstage/image will sound wider. By: JP Haggar on Sat, 25 November 2006 14:41
		There's no 'enclosure'. The front plate is 14" wide at its widest while the wings... By: jeffreybehr on Sat, 25 November 2006 15:05
		Here's a current pic of the rear. By: jeffreybehr on Sat, 25 November 2006 16:35

Previous Topic:	DCA Drivers
Next Topic:	Is it safe to hook up 4 speakers to my receiver?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 14:43:22 CST 2024