Home » Audio » Speaker » Active Crossover Question
Re: Active Crossover Question [message #22876 is a reply to message #22875] Mon, 05 December 2005 11:45 Go to previous messageGo to previous message
MikeT is currently offline  MikeT
Messages: 8
Registered: May 2009
Esquire
So I can use my existing pre amp into the xover and have volume control? I have heard that I would lose volume control through the preamp if using the Behringer. What is your experience? Are there any problems going from the balanced outputs of the xover to the unbalanced inputs of my amps? I have seen cabling that allows going from balanced to unbalanced (XLR/RCA) but have no experience with this type of set up. Any insight would be helpful. -Mike T.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: coral 8 drivers best use
Next Topic: Help Wanted
Goto Forum:
  


Current Time: Sun Oct 13 04:17:32 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest