AudioRoundTable.com: Speaker » Selah Audio XT8 Construction Photos

Home » Audio » Speaker » Selah Audio XT8 Construction Photos

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Dampening and Bracing [message #22532 is a reply to message #22530]

Thu, 10 March 2005 14:47

FredT
Messages: 704
Registered: May 2009

Illuminati (1st Degree)

Too bad about the vendor's support. After sale support has been one of the better features of the diy kits I have built from Bottlehead, Selah Audio, Sonic Frontiers, etc. I don't suppose some additional bracing could do anything but help as long as it doesn't change the internal volume of the enclosure. Today I installed the damping material in the enclosures and glued the back panels. I used the Parts Express eggcrate foam for the sides, tops and bottoms of the woofer sub enclosures but ran out (it took 8 sheets to do both speakers) so I used 3" fiberglass home insulation on the back panel.

Installing the Damping Material

Report message to a moderator

[Message index]

		Selah Audio XT8 Construction Photos By: FredT on Sat, 26 February 2005 07:38
		Re: Selah Audio XT8 Construction Photos By: Mike T. on Wed, 09 March 2005 10:46
		Dampening and Bracing By: FredT on Wed, 09 March 2005 13:41
		Re: Dampening and Bracing By: Mike T. on Thu, 10 March 2005 10:57
		Re: Dampening and Bracing By: FredT on Thu, 10 March 2005 14:47
		Re: Dampening and Bracing By: Mike T. on Mon, 14 March 2005 09:51
		Paint By: FredT on Mon, 14 March 2005 10:15
		Re: Selah Audio XT8 Construction Photos By: Bhamphile on Wed, 09 March 2005 23:13
		Re: Selah Audio XT8 Construction Photos By: Wayne Parham on Thu, 10 March 2005 02:52
		Re: Selah Audio XT8 Construction Photos By: Bhamphile on Thu, 10 March 2005 07:00

Previous Topic:	Jim Griffin
Next Topic:	Voight pipe upgrade

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 04:43:37 CST 2024