AudioRoundTable.com: Speaker » compression horn tweeter

Home » Audio » Speaker » compression horn tweeter

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: It won't work. [message #22181 is a reply to message #22180]

Thu, 29 July 2004 11:56

Bill Fitzmaurice
Messages: 335
Registered: May 2009

Grand Master

T lines do need to be properly designed and for the most part aren't used as subs as there are better/smaller ways. Full range T lines that will go to 20 Hz are viable- see Legacy.

A baffle board only works but you give up a lot of sensitivity and bass response with them. Some people like them a lot- try the planar forum at Audio Asylum.

Bi-amping requires an active crossover to operate.

Arrays can be built 3 way or 4 way if you wish, but most are 2 way.

I don't understand the last question, but I do use both EQ and a limiter on my HT system.

Report message to a moderator

[Message index]

		compression horn tweeter By: mike erb on Tue, 27 July 2004 21:43
		It won't work. By: Bill Fitzmaurice on Wed, 28 July 2004 13:45
		Re: It won't work. By: mike erb on Wed, 28 July 2004 14:11
		Re: It won't work. By: Bill Fitzmaurice on Wed, 28 July 2004 14:57
		Re: It won't work. By: mike erb on Wed, 28 July 2004 15:29
		Re: It won't work. By: Bill Fitzmaurice on Thu, 29 July 2004 05:38
		Re: It won't work. By: mike erb on Thu, 29 July 2004 10:34
		Re: It won't work. By: Bill Fitzmaurice on Thu, 29 July 2004 11:56
		Re: It won't work. By: mike erb on Thu, 29 July 2004 12:19
		Re: It won't work. By: Bill Fitzmaurice on Fri, 30 July 2004 07:01
		Re:box shape By: mike erb on Sat, 31 July 2004 16:38
		Re:box shape By: Bill Fitzmaurice on Sat, 31 July 2004 19:43
		Re:box shape By: mike erb on Sat, 31 July 2004 20:13
		Driver T/S Specs By: Bill Fitzmaurice on Sun, 01 August 2004 07:49

Previous Topic:	new DIY speaker
Next Topic:	Taking a wild guess here about cross-over design

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 15 03:15:37 CDT 2024