Home » Audio » Speaker » Looking for a single driver?
Re: But will it play Metal? [message #21238 is a reply to message #21236] Wed, 17 August 2005 06:42 Go to previous messageGo to previous message
Bob Brines is currently offline  Bob Brines
Messages: 186
Registered: May 2009
Location: Hot Springs Village, AR
Master
It all depends on what the BR/MLTL resonant frequency is. My 6" Fostex BR's have Fc=60. They are fully unloaded by 40 Hz and show significant excursion on most program material. Therefore, I cross them at 80Hz to a sub and the problem goes away. They can play very loud with little IM distortion. My 6" Fostex MLTL's have Fc=40. They don't unload significantly until below 30 Hz. There just isn't much program material down there, so excursion isn't a problem. Of course, they DO run out of excursion first at 80-100 Hz, and this is what limits the ultimate undistorted SLP.

Bob


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Shorting rings - Improve something else besides 2HD and Le?
Next Topic: Fitting JVC FS-G5 (160watt) speakers to Yamaha HTR-5839 receiver
Goto Forum:
  


Current Time: Fri Nov 29 03:46:55 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest