Home » Audio » Speaker » Why won't a single driver speaker do metal?
.page 2 [message #21131 is a reply to message #21130] |
Tue, 02 August 2005 20:10 |
Ed Schilling
Messages: 47 Registered: May 2009
|
Baron |
|
|
Martin, 1. The only thing you need to know is "The Redneck Jackal" name was a result of me being nice to an ass........long story. It's an inside joke. For some old posters at Decware. I could give a Rat's Ass if people don't get it. It was all in fun and if people hold it against me, well, so be it. Why would you bring that up? What does it have to do with my post here? About Jeff....well...... he is too smart to not know how his posts come across. I think he is "very good". You should not have made me point this out. 2. Well, like I said Enter Sandman........I don't know the FR response of the song.....it just sounds real. They are 50Hz corner horns. Read the posts at Decware....people have heard the levels I claim. As to measured response? There is a graph posted at Decware. I don't think Richard (TNT) had an X150....or any comparable amp..... What you can do is read through the posts at Decware again and read what people who have actually heard what I claim have to say. Will you not take their word for the levels I claim and that the sound was "balanced" and that I did not have a sub hooked up. What more do you need? I stated a figure, people have heard it, and they will say so, but if you don't believe either them or me? So be it. I stand by my reply to Bob's post....( some) single drivers can do Metal! 3 as noted in page 1....I said to Jeffs' post...."more like 20 db/octave below cutoff" Now really, Martin....just because I didn't say "exactly" 24 but simply spoke in "plain English" you are going to point it out......gee, sorry. But how do you know that my BLH doesn't roll off at that rate....because of your calculations? Have you measured the rolloff of mine? No? well then you should not assume you know more than me. I think some one else said 30....might be my fault but for the record I did not say that anywhere, I do not think. 4 Now that, you will have to convince me on......but I will not call you names or point out where I think you are in error....you might be right but I think there is about a snowballs' chance in Hell a sim is going to tell you how a given design that is not even real will actually sound in a room....call me a cynic. 5 That is simply completely wrong, The gains are all below 200....sorry that your guess is wrong....There is very little gain from the horn above 200. It is ALL below 200. I simply do not need your confirmation of what I hear every day and have measured. I don't need to prove it to you or anyone.....it is not hard to hear. Again, the SPLs I claim have been seen, measured, and heard by many people. I never said 105 @30 hz.....I said they can play Metallica (metal) at those levels all day long, 8 ft from the speakers.....and sound balanced and not "thin" or distorted. And my question to you is....why did you reply to my post in the first place? You did not dispute anything I said in the post per se....you just attacked and accused me of stuff I didn't do including getting technical "facts" wrong. I was much "nicer" in my reply to Bob's post than you were to mine. Why is that? Because you thought I had an "agenda", trying to "stir the pot". Well, nope.....I was simply giving my opinion as I said at the end of the post. But no big deal............One thing though, you said something about coming across as a "professional", well see, that, I'm not too worried about............most everyone already knows how I am.......A regular guy. Ed
|
|
|
|
|
Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: Martin on Tue, 26 July 2005 10:33
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Cone resonances.
By: Mike.e on Sun, 31 July 2005 23:20
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: Martin on Tue, 26 July 2005 12:44
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: Ozzy on Tue, 26 July 2005 17:03
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: zobsky on Wed, 27 July 2005 21:36
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: zobsky on Thu, 28 July 2005 12:18
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: roncla on Sat, 30 July 2005 11:02
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: roncla on Tue, 26 July 2005 16:01
|
|
|
Re: Why won't a single driver speaker do metal?
By: roncla on Tue, 26 July 2005 16:08
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: FredT on Fri, 29 July 2005 05:43
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: JLM on Fri, 29 July 2005 03:38
|
|
|
Re: Why won't a single driver speaker do metal?
By: Martin on Sun, 31 July 2005 14:56
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: Martin on Tue, 02 August 2005 18:22
|
|
|
Thank you Martin.....page 1
|
|
|
.page 2
|
|
|
my tone....
|
|
|
Re: Why won't a single driver speaker do metal?
By: roncla on Sun, 07 August 2005 07:34
|
|
|
Re: Why won't a single driver speaker do metal?
By: Regal on Thu, 28 July 2005 17:46
|
|
|
Re: Why won't a single driver speaker do metal?
By: JLM on Fri, 29 July 2005 04:42
|
|
|
You obviously haven't heard a pair of Carolina Audio speakers.
By: GTF on Sat, 30 July 2005 07:22
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
Re: hornets nest
|
|
|
SOme comments on this thread
By: akhilesh on Thu, 04 August 2005 11:35
|
|
|
Re: SOme comments on this thread
|
|
|
Re: SOme comments on this thread
By: akhilesh on Fri, 05 August 2005 07:40
|
|
|
Re: SOme comments on this thread
By: Martin on Thu, 04 August 2005 17:58
|
|
|
Re: Why won't a single driver speaker do metal?
By: Retsel on Wed, 03 August 2005 13:58
|
|
|
Re: Why won't a single driver speaker do metal?
By: akhilesh on Thu, 04 August 2005 11:24
|
|
|
Re: Why won't a single driver speaker do metal?
By: Retsel on Thu, 04 August 2005 12:09
|
|
|
Re: Why won't a single driver speaker do metal?
By: akhilesh on Thu, 04 August 2005 15:47
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: akhilesh on Fri, 05 August 2005 07:39
|
|
|
Re: Why won't a single driver speaker do metal?
By: Retsel on Fri, 05 August 2005 09:13
|
|
|
Re: Why won't a single driver speaker do metal?
By: Martin on Thu, 04 August 2005 18:08
|
|
|
a good question
|
|
|
Re: a good question
By: roncla on Fri, 05 August 2005 05:25
|
|
|
Thank You, Ron
|
|
|
Re: Thank You, Ron
By: roncla on Fri, 05 August 2005 13:49
|
|
|
Re: Thank You, Ron
By: roncla on Fri, 05 August 2005 13:58
|
|
|
Re: a good question
By: Martin on Fri, 05 August 2005 05:26
|
|
|
Re: a good question
By: roncla on Fri, 05 August 2005 05:51
|
|
|
Re: a good question
By: JLM on Sat, 06 August 2005 08:04
|
|
|
Re: a good question
By: roncla on Sat, 06 August 2005 08:43
|
|
|
Re: a good question
By: akhilesh on Fri, 05 August 2005 12:36
|
|
|
Re: a good question
|
|
|
Re: Why won't a single driver speaker do metal?
By: akhilesh on Fri, 05 August 2005 07:39
|
|
|
Re: Why won't a single driver speaker do metal?
By: Retsel on Fri, 05 August 2005 08:56
|
|
|
Ok Boys, read this........
|
|
|
Re: Ok Boys, read this........
|
|
|
Re: Ok Boys, read this........
|
|
|
Re: Why won't a single driver speaker do metal?
By: Greg B on Sat, 06 August 2005 12:15
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: Greg B on Sat, 06 August 2005 14:44
|
|
|
10-4 !
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: bob pace on Sun, 07 August 2005 07:06
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
By: bob pace on Sun, 07 August 2005 13:06
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Re: Why won't a single driver speaker do metal?
|
|
|
Further thoughts on peaks and some clarifying questions
By: akhilesh on Mon, 08 August 2005 01:42
|
|
|
Re: Further thoughts on peaks and some clarifying questions
By: bob pace on Thu, 11 August 2005 13:47
|
|
|
Maximum SPL charts
|
Goto Forum:
Current Time: Thu Nov 28 02:07:51 CST 2024
|