AudioRoundTable.com: Speaker » Initial imprssion of the Audio Nirvana 6,5

Home » Audio » Speaker » Initial imprssion of the Audio Nirvana 6,5

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Initial imprssion of the Audio Nirvana 6,5 [message #20979 is a reply to message #20975]

Sun, 05 June 2005 08:08

ronbrady
Messages: 10
Registered: May 2009

Chancellor

Hi Bob
Nice write-up on the AN driver. I'm sure that the molded magnet is much less expensive than the machined ceramic but it could have an advantage over the ceramic in that the elastic properties of the material would tend to damp the resonance of the stamped steel basket.
Just a thought.
Ron Brady

Report message to a moderator

[Message index]

		Initial imprssion of the Audio Nirvana 6,5 By: Bob Brines on Sat, 04 June 2005 09:00
		Re: Initial imprssion of the Audio Nirvana 6,5 By: Martin on Sat, 04 June 2005 19:16
		Re: Initial imprssion of the Audio Nirvana 6,5 By: ronbrady on Sun, 05 June 2005 08:08
		Re: Initial imprssion of the Audio Nirvana 6,5 By: roncla on Sun, 05 June 2005 09:31
		Re: Initial imprssion of the Audio Nirvana 6,5 By: roncla on Sun, 05 June 2005 09:23
		Re: Initial imprssion of the Audio Nirvana 6,5 By: Martin on Sun, 05 June 2005 09:32
		Re: Initial imprssion of the Audio Nirvana 6,5 By: roncla on Sun, 05 June 2005 09:38
		Re: Initial imprssion of the Audio Nirvana 6,5 By: paba on Sat, 04 June 2005 23:20
		Re: Initial imprssion of the Audio Nirvana 6,5 By: Bob Brines on Sun, 05 June 2005 04:44
		Re: Initial imprssion of the Audio Nirvana 6,5 By: paba on Sat, 04 June 2005 23:27

Previous Topic:	IN WALLS ???
Next Topic:	Acoustat Tweak Forum

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 19:16:17 CST 2024