Home » Audio » Speaker » Steak Sauce
Re: Speakerman and steak sauce? All he eats is baloney and Wonder Bread. [message #18981 is a reply to message #18980] Tue, 17 October 2006 10:58 Go to previous messageGo to next message
spkrman57
Messages: 522
Registered: May 2009
Illuminati (1st Degree)
See Wayne, all I had to do was talk about Mike and he shows up!



Re: Speakerman and steak sauce? All he eats is baloney and Wonder Bread. [message #18982 is a reply to message #18981] Thu, 19 October 2006 08:18 Go to previous messageGo to next message
SteveBrown is currently offline  SteveBrown
Messages: 330
Registered: May 2009
Grand Master
Hey, Ron, where are the M252?? Oh, and what recommendations for a top end?

Re: Steak Sauce [message #18986 is a reply to message #18968] Sun, 22 October 2006 11:18 Go to previous messageGo to next message
hurdy_gurdyman is currently offline  hurdy_gurdyman
Messages: 416
Registered: May 2009
Illuminati (1st Degree)
>For now, I’m using one EV SP-12C on each side and the bass is two EV TRXB’s in an open back box in the center crossed at about 125 hz.
Re: Steak Sauce [message #18987 is a reply to message #18986] Sun, 22 October 2006 19:32 Go to previous messageGo to next message
SteveBrown is currently offline  SteveBrown
Messages: 330
Registered: May 2009
Grand Master
Well, the TRXB's have been "modified" over time by someone else and the T35's have been removed. So no, I was just using them for bass duty. The SP-12's, I know don't have ultimate extension but I'm really surprised at the HF response - seems a lot higher than 10k to me. I think the specs say they go 15k, but that may be optimistic. Over time I will likely add a tweeter for the upper 5k or so. Right now I've added a Dayton 15" IB sub woofer powered by a seperate amp. What I did was a first order low pass at 30hz, figuring that based on the OB design, and the response of the IB speaker, I'm flat up to about 100 or 140hz, and down to 30hz (since if a first order rolls off at 6db per octave, it also rolls on at 6db per octave). I'd appreciate any comments/feedback on ways to optimize.

By the way [message #18988 is a reply to message #18986] Sun, 22 October 2006 19:33 Go to previous messageGo to next message
SteveBrown is currently offline  SteveBrown
Messages: 330
Registered: May 2009
Grand Master
Dave, I think I saw you post at the Hawthorn site, no? If so, can you give me some feedback/objective opinions on those 15" guys?

Re: By the way [message #18989 is a reply to message #18988] Sun, 22 October 2006 20:01 Go to previous message
hurdy_gurdyman is currently offline  hurdy_gurdyman
Messages: 416
Registered: May 2009
Illuminati (1st Degree)
Steve,

I am building the crossovers for the Hawthorne Audio OB 15 Coaxials, so I'm not an un-biased source for info. I do own both the coaxials and the Augies bass drivers. You can read the review on TNT of the Coaxials here>

http://www.tnt-audio.com/casse/ha_si_part1_e.html

As for the Augie bass drivers, they were designed for use on OB as a bass driver and perform well at it. Flat to around 30 Hz on a modest baffle.

Dave


Previous Topic: Full range for the beach
Next Topic: My University UC-153 drivers
Goto Forum:
  


Current Time: Sun Dec 01 01:34:19 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest