Home » Audio » Speaker » Heavy-cones verses light-cones in basshorns
Re: Heavy-cones verses light-cones in basshorns [message #18899 is a reply to message #18898] Mon, 11 September 2006 18:15 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)

That was my conclusion too. Driver mass, suspension compliance and BL are all tunable parameters that can be used along with rear chamber, front chamber and flare to set a horn for its intended application.

There was some debate about this earlier with Danley championing Leach math and woofers with relatively heavy cones and Edgar prefering Keele math and woofers with lighter cones and stiffer suspensions. I tended to see their arguments as flip sides of the same coin but the debate was on, nonetheless. Seems to have been clarified to everyone's satisfaction now.


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Time delay revisited
Next Topic: Finally the x-over is hooked up
Goto Forum:
  


Current Time: Sat Nov 30 09:58:17 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest