Home » Audio » Speaker » Any suggestions remarks on this design?
Any suggestions remarks on this design? [message #18692] Sun, 02 April 2006 17:01 Go to next message
Bas Horneman is currently offline  Bas Horneman
Messages: 9
Registered: May 2009
Esquire

it's meant to go from 400Hz down. I'm a bit worried though after reading Sound Practices summer 92 and specifically Greg Boynton's remark that folded horns suck!

The driver will be a P.Audio BM12W.

Re: Any suggestions remarks on this design? [message #18693 is a reply to message #18692] Mon, 03 April 2006 10:42 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)

I think 400Hz is probably an octave too high because folding generally attenuates higher frequencies. Standing waves develop inside that tend to make lower midrange output ragged. So crossover lower than 400Hz but otherwise it's probably a pretty good layout. Have you modeled it in Hornresp?

Thanks again Wayne. I've relayed your feedback to the [message #18694 is a reply to message #18693] Mon, 03 April 2006 15:21 Go to previous message
Bas Horneman is currently offline  Bas Horneman
Messages: 9
Registered: May 2009
Esquire
designer.

Really appreciate your sharing of knowledge. The knowledge of hornloudspeakers is a lot scarcer than say about tubes.

Regards,
Bas

Previous Topic: DIY exponential/radial horns part
Next Topic: differential dual coils
Goto Forum:
  


Current Time: Sat Nov 23 22:08:05 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest