Home » Audio » Speaker » Updated the crossovers on my K-orns to spec
Parameter shifts [message #18408 is a reply to message #18406] Thu, 12 January 2006 12:21 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)

There are changes in electro-mechanical parameters even in a single device at different operating levels. And there is a shift over time. I prefer to use alignments that are relatively insensitive to these shifts, basically systems with a wide tolerance. You can model a system at various operating points to see how it will act, and then if industrious enough, measure a physical model at several power levels to see if it performs as expected. I think a system should be designed to allow for pretty wide shifts in driver parameters, because that's what it will encounter. A side benefit of this is that small tolerance changes in component production runs won't matter so much.


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Ciare HX-201 10" wideband?
Next Topic: Commercial Line Arrays?
Goto Forum:
  


Current Time: Fri Nov 29 23:25:35 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest