AudioRoundTable.com: Speaker » Checking with meter

Home » Audio » Speaker » Checking with meter

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Checking with meter [message #17762]

Mon, 25 April 2005 18:11

adavis464
Messages: 64
Registered: May 2009

Viscount

I get 7.5 ohm reading that does not seem like a 16 ohm driver?Is this correct for a 16 ohm driver.I don't think so help

Report message to a moderator

Re: maybe [message #17764 is a reply to message #17762]

Mon, 25 April 2005 21:10

tomt
Messages: 40
Registered: May 2009

Baron

what driver is it?

Report message to a moderator

Re: Checking with meter [message #17765 is a reply to message #17762]

Tue, 26 April 2005 03:39

Wayne Parham
Messages: 18723
Registered: January 2001

Illuminati (33rd Degree)

When you measure with a meter, what you see is DC resistance and that's only part of impedance. The other part is voice coil reactance, and that won't show up on a meter. Typical DC resistance value for an 8 ohm driver is 4-6 ohms, for a 16 ohm driver it's usually 8-12 ohms. Some are a little higher or lower.

Report message to a moderator

They are marked jbl 2440 16 ohm [message #17767 is a reply to message #17764]

Tue, 26 April 2005 10:32

adavis464
Messages: 64
Registered: May 2009

Viscount

Hi tomt With original diaphrams Regards Tim

Report message to a moderator

For example... [message #17768 is a reply to message #17765]

Tue, 26 April 2005 10:51

GarMan
Messages: 960
Registered: May 2009

Illuminati (2nd Degree)

Couldn't find the specs for 2440, but according to JBL specs, the 2445J has DC resistance of 8.2 ohms, +/- 10%. A 7.5 reading would be within spec for this 16 ohm driver.

Report message to a moderator

Previous Topic:	neat trick for corners in rear horns, xmission lines
Next Topic:	I need help in the creation of a midbass horn...

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 14 13:23:37 CDT 2024