Hello! nice new forum!

had the wood cut,he quoted me 2weeks + before he could cut it..he took 3days,which annoyed me because i changed it so that the hole + cover is on the front flare panel ,for easy driver switching..

the wood was cut perfectly by him ,Apart from 1 angle,which is probably my fault,i cant be bothered figuring it out whos fault it was :-P il just file it down. Also File the sharp interior path corners.

The driver is an 8" i came across for 19$.normally 60$,cheap because the company doesnt sell them anymore.

Just a 40hz horn,about 143litres.its a good coffee table size-but wouldnt function in middle of room with that tiny mouth.

Its been along time coming..and i did make some slightly little errors,however it will still work.

Ive finished tech for the year.We went as far as reactive circuits and then moved onto real and imaginary power etc

I did see the acoustical impedence curves.and had a discussion at Cornus horn forum about it with the quarter-wave.com guy i think.

Its nice to know that you can model mechanical filters closely,with electrical ones :-)

Cheers

Complete!
SPL meter later.
lab12 woofer next.

See my site

• http://homepages.paradise.net.nz/quadroph/

Let us know how they sound, and if you would recommend others follow in your footsteps on this one.

They sound very pure. you can distinctly hear the pure tones at 50hz (excursion minimum)
the distortion at 40hz,where excursion is 7mm (xmax is only 3.5mm!)
and then at 30hz and below,i can hear it in car,but its quiet.

with my new job,SPL meter very soon!

I hurt myself listening to it in car cant wait for SPL results! :P

Cheers~