Home » Audio » Speaker » Speaker Wire/Setup/Receiver Question
Re: Speaker Wire/Setup/Receiver Question [message #15711 is a reply to message #15710] Fri, 15 August 2008 11:06 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18774
Registered: January 2001
Illuminati (33rd Degree)

Are all three connected in parallel? If so, the load impedance presented to the amplifier may be too low. That will cause more current draw than the amp is capable of, causing it to go into protection mode when the volume is turned up.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Previous Topic: Arrays in the time domain
Next Topic: ART array - What might be the effects of narrowing baffle on
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 09 05:20:01 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest