AudioRoundTable.com: Speaker » Finally the x-over is hooked up

Home » Audio » Speaker » Finally the x-over is hooked up

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Finally the x-over is hooked up [message #15378 is a reply to message #15377]

Tue, 12 September 2006 23:25

wunhuanglo
Messages: 912
Registered: May 2009

Illuminati (2nd Degree)

I apologize for being typically dense.

The Altec method for aligning the drivers, as I remember it, is to wire the drivers out-of-phase and play a tone at the crossover frequency (here, as with most Altec speakers, 800 Hz). You then find the fore-and-aft position that yeilds an SPL minima - at that point the drivers are in the proper physical alignment.

Report message to a moderator

[Message index]

		Finally the x-over is hooked up By: MWG on Sat, 09 September 2006 21:33
		Re: Finally the x-over is hooked up By: wunhuanglo on Mon, 11 September 2006 04:27
		Re: Finally the x-over is hooked up By: MWG on Mon, 11 September 2006 08:06
		Re: Finally the x-over is hooked up By: wunhuanglo on Mon, 11 September 2006 15:45
		Re: Finally the x-over is hooked up By: MWG on Mon, 11 September 2006 19:26
		Re: Finally the x-over is hooked up By: wunhuanglo on Tue, 12 September 2006 23:25
		Re: Finally the x-over is hooked up By: MWG on Wed, 13 September 2006 08:09

Previous Topic:	Heavy-cones verses light-cones in basshorns
Next Topic:	interesting damping material

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 19:57:15 CST 2024