|
|
|
|
|
|
Western Electric Engineers? [message #14901 is a reply to message #14895] |
Fri, 18 March 2005 19:40 |
FredT
Messages: 704 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
Here's some information from a hi fi history that dates the first two way speakers to 1931: "The early Western Electric theater systems were of one-way design consisting of large re-entrant type exponential horns. The Western Electric 555 driver was used with these large assemblies. Frequency response was band limited, and the range covered was probably no more than 100 Hz to about 5,000 Hz. Later on, Western Electric added a high-frequency unit as well as an array of low-frequency woofers to augment these systems. They used Jensen 18" woofers in open-back enclosures to supplement low frequencies and a device known as the Bostwick tweeter to extend the upper range. These additions to the basic one-way system appeared in 1931". But this takes the term "woofer" for granted and does not specify whether the Western Electric engineers called their drivers "woofers" and "tweeters", or whether those terms appeared later. Looks like I don't get the dollar.
|
|
|
Re: Western Electric Engineers? [message #14902 is a reply to message #14901] |
Sat, 19 March 2005 09:20 |
wunhuanglo
Messages: 912 Registered: May 2009
|
Illuminati (2nd Degree) |
|
|
The only etymology I could find is that the both first appeared in 1934. I did scan Rice & Kellog's 1925 paper and the concept was not mentioned there - although they did build a three-way horn speaker at that time as one of their configurations. Another reference, Briggs' survey of 1941 - did not use the term, so I would guess it was either not in wide use or only in use in the USA.
|
|
|
|