AudioRoundTable.com: Speaker » pairing speakersw to tube amps

Home » Audio » Speaker » pairing speakersw to tube amps

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

pairing speakersw to tube amps [message #14644]

Sat, 24 July 2004 09:30

jim denton
Messages: 162
Registered: May 2009

Master

Check out my thinking guys----I'm shopping speakers and I want to use my 17-20 wpc tube amps on these new speakers---I have found several that say Max power 100 watts---but not a good operating power range---others at 88 or 89 db rating---and finally, most important for my tubes the load---there are no 16 Ohm speakers that I know of---most are 8 Ohm load---so---If I bought a pair of speakers that are 88db rated at 8 Ohms ( some say they don't go much below 6 Ohms which is good ???) I could use them Ok in my smallish listening room just not blowing out the windows?? I don't really crank up the volume to much amyway---MY thoughts are that I could run these Ok and just never have all the power that they could use? JD

Report message to a moderator

Re: pairing speakersw to tube amps [message #14645 is a reply to message #14644]

Sun, 25 July 2004 21:16

Wayne Parham
Messages: 18783
Registered: January 2001

Illuminati (33rd Degree)

I think it will work just fine, Jim. If they're rated 88dB/W/M and your maximum power is 20 watts RMS, I think they'll sound about as loud as a 2 watt Decware Zen or Paramour amp on a pair of classic Klipsch or π speakers. Maximum volume is loud enough that you have to speak loudly to talk to someone in the listening room, but not so loud that you have to yell.

Report message to a moderator

Previous Topic:	A few questions
Next Topic:	Any ideas for a cabinet design?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 18 03:31:48 CST 2024