AudioRoundTable.com: Source » Rek-O-Kut project finished at last!

Home » Audio » Source » Rek-O-Kut project finished at last!

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Rek-O-Kut project finished at last! [message #13476 is a reply to message #13475]

Wed, 22 August 2007 13:52

hurdy_gurdyman
Messages: 416
Registered: May 2009

Illuminati (1st Degree)

That should have stated above that the mat was from a DP-75, not a TP-75. Brain fart...

Dave

Report message to a moderator

Re: Rek-O-Kut project finished at last! [message #13497 is a reply to message #13441]

Fri, 31 August 2007 08:56

hurdy_gurdyman
Messages: 416
Registered: May 2009

Illuminati (1st Degree)

Just wanted to post that my Yahoo photos of the Rek-O-Kut project has been moved to Flickr.

http://www.flickr.com/photos/12271467@N03/sets/72157601762905060/

Dave

Report message to a moderator

Re: Rek-O-Kut project finished at last!--The O-Ring Idler [message #13500 is a reply to message #13441]

Sat, 01 September 2007 16:35

David Lawrence
Messages: 3
Registered: May 2009

Esquire

Hi,
Could you say anything about how you had this made? Was it a modification of a ready-made idler pulley? Did you use a sintered bronze bearing or a bushing below? What size and thickness of o-ring did you use? How much did the machine shop charge? Thanks a lot for any advice.
David

Report message to a moderator

Re: Rek-O-Kut project finished at last!--The O-Ring Idler [message #13502 is a reply to message #13500]

Sat, 01 September 2007 20:03

hurdy_gurdyman
Messages: 416
Registered: May 2009

Illuminati (1st Degree)

>Hi,
Could you say anything about how you had this made? Was it a modification of a ready-made idler pulley? Did you use a sintered bronze bearing or a bushing below? What size and thickness of o-ring did you use? How much did the machine shop charge? Thanks a lot for any advice.
David

Report message to a moderator