AudioRoundTable.com: Source

Home » Audio » Source » overhang

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

overhang [message #13306]

Wed, 07 March 2007 00:07

kpl017
Messages: 3
Registered: May 2009

Esquire

Is it possible to adjust for correct cartridge alignment at the 2 null points with different overhang distances? Assuming, of course, the same arm and cartridge on the same table. Or, is there only 1 overhang that goes with successfully adjusting to the null points?
Guess I'm also trying to figure out whether it is possible to determine the correct overhang for any arm with no known overhang specs. Any info or opinion much appreciated.

Report message to a moderator

Re: overhang [message #13310 is a reply to message #13306]

Wed, 07 March 2007 13:27

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

I'm not sure if that specific question is answered in the documents below, but I think it's probably worth looking.

Report message to a moderator

Re: overhang [message #13312 is a reply to message #13306]

Thu, 08 March 2007 17:51

dvautier
Messages: 6
Registered: May 2009

Esquire

I would say yes at least for midrange and high quality TTs. On each of the headpieces I have there is a slot that is about ¼ inch. I have never bothered to measure overhang and I usually set the cartridge at about 2/3rds of the way down the slot.

Report message to a moderator