Re: Magnepa Unitrac I Tonearm kicks Arse! [message #13076 is a reply to message #13075] |
Sat, 09 September 2006 10:25 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) ![Go to next message Go to previous message](/forum/theme/AudioRoundTable/images/down.png) |
Russellc
Messages: 397 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
Same here, as to the Moerch anyway. Just turned one down for 406.00, only because it had the heavy tonearm, so I would have to replace it, was missing a few odds and ends, and was the older one where the arm holder is a seperate piece requiring a hole drilled in the plinth, which might not be the best idea with a sprung table. also lost out on an auction for a DP 6...winning bid, just over 700 with my esnipe set a few bucks short. I already have a co polymer subchassis from Merrill/Scillia cut for a Moerch. I WILL FIND ONE YET! Russellc
|
|
|