AudioRoundTable.com: Source » Technics 1200 Output Problem

Home » Audio » Source » Technics 1200 Output Problem

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Technics 1200 Output Problem [message #12885 is a reply to message #12884]

Tue, 09 May 2006 06:17

Manualblock
Messages: 4973
Registered: May 2009

Illuminati (13th Degree)

Probably loose cartridge pins. It's pretty rare that wire inside the arm is defective. But think of this; if you are getting continuity from the table to the RCA plug then the signal should be getting through. At this point there is not much that you can check on the table; try checking the continuitynfrom the cartridge pins to the RCA plug one at a time.

Report message to a moderator

[Message index]

		Technics 1200 Output Problem By: Mention on Mon, 08 May 2006 21:50
		Re: Technics 1200 Output Problem By: Mention on Mon, 08 May 2006 23:01
		Re: Technics 1200 Output Problem By: Manualblock on Tue, 09 May 2006 06:17
		Re: Technics 1200 Output Problem By: Mention on Tue, 09 May 2006 23:31

Previous Topic:	DN990r md recorder error codes on used gear?
Next Topic:	Numark mixer cuts out after every track

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 11 01:43:46 CST 2024