Home » Audio » Silicon Valley » chips and tubes
Re: chips and tubes [message #10260 is a reply to message #10259] Thu, 09 December 2004 23:04 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)
Sometimes I use open loop opamps to digitize an input signal. The gain is so high it swings to the rail upon getting any input at all.

Re: chips and tubes [message #10284 is a reply to message #10248] Mon, 17 January 2005 09:45 Go to previous messageGo to next message
JLM is currently offline  JLM
Messages: 69
Registered: May 2009
Viscount
Glad to hear someone else thinks the same of the HK 3470. I bought mine factory reconditioned for $160 shipped to use in a puny 2.1 HT system and it compares sound wise very well with my Rotel receiver that was $700 (the tuner is even better). I'm sure the build quality doesn't compare, especially on the front panel controls.

Re: chips and tubes [message #10285 is a reply to message #10284] Mon, 17 January 2005 10:23 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)
Ditto. That's what I use mine for, a little second home theater system. I originally intended it mostly as a demo for a low cost setup, and thought I'd mothball it when not being used for that purpose. But the truth is it probably gets more use than my primary home theater system. Partly that's because it's convenient and partly that's because the system sounds so good.

Previous Topic: Headphone amp
Next Topic: Surround Processor Q
Goto Forum:
  


Current Time: Fri Nov 22 14:08:00 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest