|
113 Search Results Found |
1 |
Forum: Source «»
Posted on: Tue, 29 November 2005 15:57 «»
By: Manualblock
Re: Help needed with a turntable purchase
My opinion. If you listen for pleasure and not for perfection; want a good sounding, reliable turntable that can be somewhat upgraded in the future should the notion take you and works well with many of the better cartridges then I would suggest getting a...
|
2 |
Forum: Source «»
Posted on: Sat, 19 November 2005 22:50 «»
By: Anonymous
Re: Turntable hum
My set up is really simple. Turntable --> preamp --> speakers/headphones. The preamp itself is grounded; it has a 3-pin power plug and it has never been altered in any way.The phono stage, if I understand you correctly (I may not be very familiar with ter...
|
3 |
Forum: Source «»
Posted on: Sat, 19 November 2005 06:55 «»
By: Manualblock
Re: Turntable hum
O'Kay; lets see. Can you indicate if there are any other grounding schemes you are using on the rest of your set-up? Like three into two prong plugs or say; Plugging your amp into the back of the pre-amp, those kind of things. I had a problem once with th...
|
4 |
Forum: Source «»
Posted on: Sat, 12 November 2005 20:33 «»
By: DCE
Re: Shure V 15Vxmr initial disappointment. Help needed!
Hello. Remember the Shure is sensitive to the loading capacitance. The recommended load (250pf? if I remember correctly) has been shown in articles to be pretty much a max value for a slight roll-off in the treble and minimal resonance "ringing" above t...
|
5 |
Forum: Source «»
Posted on: Thu, 15 September 2005 19:45 «»
By: Manualblock
Re: looking for rca cables
Whats economy? The Bottlehead Seduction sounds better than most out there; at least under the 1k mark. Thats about 250.00$For 60$ there is a nice op-amp semi-kit from several manufacturers. Some people on this forum use them.Some friends of mine use a lit...
|
6 |
Forum: Source «»
Posted on: Wed, 24 August 2005 14:23 «»
By: Manualblock
Re: Phono Stage
Either one would sound very good. Try a used EAR 831P also. They can be had for about 500$.
|
7 |
Forum: Source «»
Posted on: Mon, 22 August 2005 11:47 «»
By: Wayne Parham
Re: Phono Stage
There have been a lot of discussuions here about phono stages:Search results for "phono stage"
|
8 |
Forum: Source «»
Posted on: Mon, 22 August 2005 05:44 «»
By: Carlos Banha
Phono Stage
Could someone help me?I want to buy a phono stage to connect my Rega P3 turntabel (Elys MM cartridge) to the Prima Luna Prologue Two (tube amp).Since I'm a kind of a rookie I'd appreciate all suggestions you send me about phono stages. I Thought maybe Tri...
|
9 |
Forum: Source «»
Posted on: Tue, 02 August 2005 12:10 «»
By: Manualblock
Re: Dual CS508 Sounds terrible
What you describe does not soundlike a bad bearing. It sounds like a poor quality contact between the cartridge pins and the leads. If you can clean and gently dis-connect and gently re-connect the leads to the cartridge pins I think you may find some imp...
|
10 |
Forum: Source «»
Posted on: Sat, 23 July 2005 20:34 «»
By: GarMan
Re: OP Amp Upgrade
Thanks for the heads-up on the OPA627 Fred. I'd always thought the Burr Brown OPA2134 was a highend opamp. Many kits suggest using the 2134 as an upgrade. The phono stage I build using these sound very good to me. But I'd definately experiment with th...
|