AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Need Plans

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Need Plans [message #35883]

Mon, 08 April 2002 20:09

Nashvilletitans
Messages: 11
Registered: May 2009

Chancellor

Could I please get a set of Theater 4 plans? Would very much like to build a set of these. Thanks
John

Report message to a moderator

Or advice [message #35884 is a reply to message #35883]

Mon, 08 April 2002 20:15

Nashvilletitans
Messages: 11
Registered: May 2009

Chancellor

Would the Thermionic Studio Series 4 be a better choice with an SET 8 watt 300b amp? Thanks again,
John

Report message to a moderator

You have mail! [message #35886 is a reply to message #35883]

Mon, 08 April 2002 20:37

Wayne Parham
Messages: 18677
Registered: January 2001

Illuminati (33rd Degree)

Report message to a moderator

Thermionic or Theater 4 - An often asked question [message #35887 is a reply to message #35884]

Mon, 08 April 2002 20:39

Wayne Parham
Messages: 18677
Registered: January 2001

Illuminati (33rd Degree)

The Theater Series four π Speaker is marginally more efficient, but the Thermionic four π goes a bit deeper. The Thermionics have a different damping value so they sound fuller, and the midrange takes on a slightly different character too, having a sound that I would describe as vintage tube sound. But they are very large.

Report message to a moderator

Thanks Wayne [message #35888 is a reply to message #35883]

Mon, 08 April 2002 21:02

Nashvilletitans
Messages: 11
Registered: May 2009

Chancellor

WOW, that was quick, thanks a million Wayne!
John

Report message to a moderator

I'm curious [message #35907 is a reply to message #35887]

Wed, 10 April 2002 09:18

dbeardsl
Messages: 127
Registered: May 2009

Master

You mentioned that the Thermionic Four Pi has a tiny bit more extension at the top end?

Whats different about em? They both use the 2002 right? Is there a little more top octave compensation?

I just ordered some plywood blades for the skilsaw, some 36" clamps, and a cutting guide/straight edge thingy. I'm set :-).
I'll take lots of pictures of course.

Report message to a moderator