BigmouthinDC wrote on Thu, 05 August 2010 09:26 |
I found some 3/4 x 1 1/2 and 3/4 x 2 Oak in my scrap pile. I positioned it about as low as I can go to create the "shelf" for the recommended insulation installation separating the woofer from the port. |
krikor wrote on Thu, 05 August 2010 10:33 |
Something I've been wondering about with regards to the 4Pi port that is evident in this photo... since the port is so close to the cabinet side wall, could you just build a three-sided port and use the cab sidewall as the fourth side? |
BigmouthinDC wrote on Sun, 29 August 2010 17:04 |
First report. I turned on some Satellite Smooth Jazz and set my Receiver to stereo. When sitting in the masters chair, 3 times I had to get up and put my ear to the center channel because that was were most of the sound was located but of course it was turned off. These things would be phenomenal for anyone needing to run a phantom center channel. |
BigmouthinDC wrote on Sun, 29 August 2010 19:20 |
It seemed like dampening the horn would be a good idea or at least couldn't hurt. |
BigmouthinDC wrote on Sun, 29 August 2010 19:20 |
screwed the crossovers in on a 1/8 inch rubber pad. |
BigmouthinDC wrote on Sun, 29 August 2010 19:20 |
Then the recommended insulation on the bottom, back, a cross section at the brace and the side by the port |