AudioRoundTable.com - RDF feed
type: channel
description: Audio advice and discussions with audiophiles and professionals. Free discussion forums, open to all and frequented by industry experts. Ask questions and get advice on stereos, speakers, hi-end amplifiers, pre-amps, home theater, tube hi-fi, turntables, vinyl, tweaks, music, films, video, DVDs and more.
items: Active xover's
items: Re: Active xover's
items: Re: Active xover's I hate typos

Active xover's
type: item
description: With active xover's you have to pay attention to ohm's of the driver. With actives you don't. I'm assuming they automatically correct somehow or are they set for 8 ohm and aren't true for other impedences? Thanks in advance. Grant.
creator: GrantMarshall
date: 2005-07-28T10:13:55-00:00

Re: Active xover's
type: item
description: Opps. Change the "With active xover's you have to pay attention to ohm's of the driver." to "With passive xover's you have to pay attention to ohm's of the driver." Thanks, Grant.
creator: GrantMarshall
date: 2005-07-28T11:21:01-00:00

Re: Active xover's
type: item
description: Hi Grant- an active crossover splits the signal into frequency bands before the output amplifiers. The impedence of the drivers od not directly affect the crossover frequency, as in passive crossovers. However, driver impedence is inversely proportional to output (with solid state amps)- the 8 ohm power output of a power amp is about 1/2 of what the 4 ohm output is- 16 ohm would be half of what the 8 ohm rating is. As a practical matter, you can use the gain controls on the amp or crossover to balance outputs and levels so the result is acceptable. Figure no more than 4 ohms for any driver (or combination of drivers) and most any amp will be happy. Larry Acklin
creator: Larry Acklin
date: 2005-07-28T14:33:54-00:00

Re: Active xover's I hate typos
type: item
description: The impedence of the drivers DO not directly affect the... Figure NO LESS than 4 ohms for any driver...
creator: Larry Acklin
date: 2005-07-28T15:43:53-00:00

Re: Active xover's
type: item
description: Thanks for the response Larry. I understand it now I think. With freqency division only a certain range makes it to the amp. If you mixed 4 and 8 ohms one amp would work harder as a result of it. As long as you use integrated amps you can adjust. Thanks again. Grant.
creator: GrantMarshall
date: 2005-07-28T19:19:24-00:00