AudioRoundTable.com - RDF feed
type: channel
description: Audio advice and discussions with audiophiles and professionals. Free discussion forums, open to all and frequented by industry experts. Ask questions and get advice on stereos, speakers, hi-end amplifiers, pre-amps, home theater, tube hi-fi, turntables, vinyl, tweaks, music, films, video, DVDs and more.
items: Compensation Network connection
items: Re: Compensation Network connection

Compensation Network connection
type: item
description: About to solder the tweeter compensation resistors together, along with the capacitor. I hope this diagram is understanble, but want to make sure I've got it before I commit solfer. The diagram below should represent 4 pairs of 16 ohm resistors in parallel serial combination. Top View of Resistor Pack O----O----O----O O----O----O----O Bottom View of Resistor Pack T1------O----O O----O-----C3 | | T2------O----O O----O | | |-||-| C1 Thanks Hakn
creator: HaknHendrix
date: 2004-03-24T01:53:05-00:00

Re: Compensation Network connection
type: item
description: Not sure if this is what your looking for, but I think it is. See this post: http://www.audioroundtable.com/PiSpeakers/messages/13262.html Adrian
creator: Adrian Mack
date: 2004-03-24T02:35:26-00:00

Re: Compensation Network connection
type: item
description: OK - I'm ready to fire up the soldering iron - well almost. I sharpened my pencil, diagrammed the compensation network based on the 4 Pi schematics Wayne sent me - lots of lines connecting the resistors (series/parallel), and built a 3 dimensional model out of cardboard. I then looked at the URL sent to me with the attached graphic: http://www.audioroundtable.com/PiSpeakers/messages/13262.html and modeled this out of cardboard - and they are two different beasts. So, if I duplicate the compensation network based on the picture provided via the URL - I feel like I should be Good to Go. It will be connected to the Eminence PCB. The woofer compensation network looks easier - connect the dummy resistor to the capacitor, and connect the leads in parallel prior to connecting to the woofer.
creator: HaknHendrix
date: 2004-03-31T13:24:39-00:00

Re: Compensation Network connection
type: item
description: I have a suggestion. When you build-up your cluster of four resistors to make R1 and another four to make R2, measure them with a DVM to make sure the result is 16 ohms for each one. It's just a series-parallel connection that is physically shaped in a way that's convenient.
creator: Wayne Parham
date: 2004-03-31T23:04:55-00:00