AudioRoundTable.com - RDF feed
type: channel
description: Audio advice and discussions with audiophiles and professionals. Free discussion forums, open to all and frequented by industry experts. Ask questions and get advice on stereos, speakers, hi-end amplifiers, pre-amps, home theater, tube hi-fi, turntables, vinyl, tweaks, music, films, video, DVDs and more.
items: CCS module
items: Re: CCS module -another view

CCS module
type: item
description: Today I finished CCS module on PCB, LED+BC558B/MJE350 version, from the book "Valve Amplifiers - third edition" by Morgan Jones. I can`t post the schematic, it`s on the page 138. Two transistor cascode, 120 Ohms resistor is set for 8mA, for larger current this R must be lower. Well, I use marker + my favorite nail-polish (hehe), and results are not that spectacular, but "good enough". Then Fe-III-Chlorid does the rest. I fixed the heat sink with 2 mm screw from the Cu-side (tricky, sink is only 4 mm thick). Small dimensions of the board (33x75 mm) need precision... I added C1=1uF/630V MKT cap for local decoupling. One of these days, I`ll try it (2A3 driver load, etc.). And one more thing - I did my best to build it and describe it, but can`t guarantee the success...doesn`t mean to discourage anybody, but lot of patient work is needed... And beware of high voltage...
creator: Damir
date: 2005-02-13T14:40:05-00:00

Re: CCS module -another view
type: item
description: Even to photo this little creature is not easy...
creator: Damir
date: 2005-02-13T14:43:06-00:00

Re: CCS module -another view
type: item
description: Very nice work Damir; keep this up and before you know it you will be in business! I built the Bottlehead CCS boards. If it would be any help to anyone I can photo or provide any info concerning those units. They have a tutorial in the manual that tells how to figure values of components on the board.
creator: Manualblock
date: 2005-02-13T14:56:21-00:00

Re: CCS module -another view
type: item
description: Well, I`m not too proud for the quality of the traces and soldering (too much PC, too little PCB), but I hope it`ll be allright:-). Anyway, thanks to "ImageShack"! P.S. Of course, if somebody wants to build it, first adjust it to your actual components dimensions, and check the orientations of the components/Cu traces twice...:-) And beware of high voltage, and good luck, and...
creator: Damir
date: 2005-02-13T15:05:11-00:00