AudioRoundTable.com - RDF feed
type: channel
description: Audio advice and discussions with audiophiles and professionals. Free discussion forums, open to all and frequented by industry experts. Ask questions and get advice on stereos, speakers, hi-end amplifiers, pre-amps, home theater, tube hi-fi, turntables, vinyl, tweaks, music, films, video, DVDs and more.
items: Screw on adapter
items: Re: Screw on adapter

Screw on adapter
type: item
description: I am using a adapter plate to make my psd 2002 screw on work with the 290 horn with the bolt on pattern, Does this cause any problems ??? As always Thanks for your reply..
creator: Wayne-o
date: 2009-04-23T18:03:38-00:00

Re: Screw on adapter
type: item
description: Those screw-on adapters usually modify the throat expansion. Look at it and see how thick the mounting plate is. If very thin, it might not be too bad. The cross-section area usually remains constant through the thickness of that plate, basically just a 1" hole. The compression driver has an 8° flare exit angle which matches the entrance angle of the horn. The horn gradually expands that flare rate, setting the wave shape and coverage pattern. When you install an adapter, this is changed. The 8° flare angle at the compression driver exit interfaces with a 0° section in the adapter, basically a short straight pipe, for some distance. It then goes back to 8° at the horn throat entrance and expansion continues from that point. This poor interface results in a discontinuity that causes internal reflections and it occurs at a very sensitive place in the horn. In some cases, I would expect severe spikes in the top end, in others, it may not be as noticeable. You could always bolt it on, measure it and see. Might knock down some of the breakup modes, but then again, it might make them worse. Hard to say without measurements. It will almost definitely have an impact, and I would not expect it to be a positive one.
creator: Wayne Parham
date: 2009-04-23T19:34:23-00:00

Re: Screw on adapter
type: item
description: Wayne, This 8° angle means that I should attach the driver to the horn in a specific position? Well, it's not that I have too many choices... but it seems that I have 2 ways to do it when using the 2 bolts that match driver/horn. What is the right way? Thanks!
creator: reguax
date: 2009-04-23T20:03:22-00:00

Re: Screw on adapter
type: item
description: The flare is axisymmetrical so the rotational position doesn't matter.
creator: Wayne Parham
date: 2009-04-24T02:37:38-00:00