Posted by manualblock [ 24.191.167.32 ] on December 06, 2004 at 14:05:22:
In Reply to: Re: Actual bias vs set bias/antiskate posted by Russelc on December 06, 2004 at 11:39:54:
The indentations that occur across the t-bar sections of the suspension, fill them with hot glue to damp them down. You have a point there, about the "periferie" clamp. As far as balancing the platter I just used a weighted amount for each pie-shaped section and then checked with a bubble level. Not so sophisticated and I probably would not do that on my Linn but It seemed o'kay so far; time will tell.
Ortofon makes nice sounding carts. Wish I had the means for a nice SPU with the Tonearm and their step-up. 5k$ sounds fair for a phono needle; eh?
[ Turntable Forum ] [ Help ]