Posted by manualblock [ 69.112.43.172 ] on May 09, 2006 at 07:17:23:
In Reply to: Re: Technics 1200 Output Problem posted by Mention on May 09, 2006 at 00:01:39:
Probably loose cartridge pins. It's pretty rare that wire inside the arm is defective. But think of this; if you are getting continuity from the table to the RCA plug then the signal should be getting through. At this point there is not much that you can check on the table; try checking the continuitynfrom the cartridge pins to the RCA plug one at a time.
[ Turntable Forum ] [ Help ]