Posted by Bill Epstein [ 12.75.72.53 ] on August 08, 2005 at 17:06:26:
In Reply to: Re: HELP with my Acoustic Research XA! posted by manualblock on August 08, 2005 at 13:50:47:
If you remove the bottom cover you will find there is a solder terminal where the spider thin strands of wire from the cartridge/arm connect to the output cable. They are very fragile!
There is neutral and hot just like at the cartridge pins for each channel plus a separate ground. I recall then being color-coded like the cartridge but I'm not certain.You may have a partial short to ground on the bad channel so resoldering those leads might help.
In any case, further help is available fron DDarch at Vinyl Nirvana or The Analog Dept
[ Turntable Forum ] [ Help ]