Posted by Shane [ 24.248.121.231 ] on August 31, 2006 at 10:47:27:

I am learning how to do loadlines from MJ's book and Steve Bench's webpages and just want to make sure I'm understanding it.

Looking to draw a loadline for 6EM7 section 2. Steve states that the load (Z)=(max V - quiescent V)/quescient I. I'm looking at Ic=50mA and Vq=210V. Is the load the primary impedance for the OPT? So if I'm using a 5K OPT the max V on the loadline at 0 plate current would be 460V. Then draw a line from the 460V,0mA point through the 210V,50mA point and figure all the other parameters from there?

I refuse to build anyhting till I can go through and explain/understand why everything is what it is.

Thanks

Replies:

• Duh! - Shane 15:14:40 09/01/06 (0)
• Re: Loadlines - manualblock 11:23:43 08/31/06 (9)
  • Re: Loadlines - Damir 09:09:38 09/05/06 (3)
    • Trying these for 5K - Shane 18:07:51 09/05/06 (2)
      • Re: Trying these for 5K - Damir 07:10:52 09/06/06 (1)
        • Thanks Damir!! - Shane 22:15:34 09/07/06 (0)
  • Re: Loadlines - Shane 11:29:14 08/31/06 (4)
    • Re: Loadlines - manualblock 21:37:04 08/31/06 (3)
      • Before you whip out the plastic! - Shane 09:08:38 09/01/06 (2)
        • Re: Before you whip out the plastic! - manualblock 11:13:34 09/01/06 (1)
          • Re: Before you whip out the plastic! - Shane 11:47:46 09/01/06 (0)