Posted by 2wo [ 71.242.34.247 ] on May 21, 2006 at 22:13:48:

In Reply to: Re: How did I do the power supply...Badly posted by manualblock on May 19, 2006 at 07:52:03:

Hi M,
The boards I am using are the ones Bas Horneman had done up as a group buy over at DIY. There are some small differences (JB adds some decopling caps, Bas adds a trim pot ect..) but you can take the same hand full of parts and use either with success. JB’s board was not available when I built mine.
Are you sure that JB’s board is set up for the 5687? It has that odd pinout, which leaves it off my favorite list. I will try to check later.

If you have not been to the Tube cad site lately, in the last few bolgs there are PDF manuals as well as a big chart of tubes, with recommended cathode resistors and everything. Good stuff…John

Replies:

• Re: How did I do the power supply...Badly - manualblock 07:56:33 05/26/06 (3)
  • Aikido 5678 PCB - 2wo 14:10:26 05/29/06 (2)
    • Re: Aikido 5678 PCB - manualblock 12:45:46 05/30/06 (1)
      • Re: Aikido 5678 PCB - 2wo 23:23:01 05/30/06 (0)