Posted by hurdy_gurdyman [ 4.229.195.104 ] on September 08, 2005 at 08:20:57:

In Reply to: Hmm... posted by Damir on September 08, 2005 at 00:46:02:

Looking at the pin wiring, pin 1 is grounded on each tube. Pin 8 was grounded as well, but I lifted this and hooked all four pin 8's together and grounded them through the 20 ohm resistor. Should I un-ground pin 1 and wire it to pin 8?

Dave

Replies:

• actually... - hurdy_gurdyman 08:38:10 09/08/05 (1)
  • Re: actually... - hurdy_gurdyman 10:14:34 09/08/05 (0)