In Reply to: corner horn answers posted by Wayne Parham on November 21, 2002 at 19:37:44:
Hi guys,
I have wondered about cutting a filet from the outer middle mass of the rear supports(the dog house roof, if you put a 7Pi on its face)to clear a similar obstruction. This leaves support at top and bottom to suppress panel flex. If you did the rear uprights in heavy ply it would be solid. Essentially an arch with a triangle cross section.(STRONG) Wayne, do you think this would work. see pathetic attempt at ascii art below. If not here, maybe this will help a 7Pi live somewhere it might not have.I reluctantly assume:
-Baseboard heaters dont meet in the corner. All I have seen come within 6" or so and stop. Hope I'm right.
-Because the supports and the corner behind them have the same shape, the acoustic penalty is small or none.
-The small heater being in the big throat should be ok, yes?below represents 1 of the mirrored pair to be joined at 45 for the rear "spine". I truncated it to for sake of time, but I think the Idea conveys.
Later, Thomas
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Follow Ups: