Posted by Pilkar on April 15, 2002 at 12:40:41

In Reply to: Re: crossover design... help.... posted by Wayne Parham on April 15, 2002 at 11:41:29:

hi Wayne,
thank you very much for your reply... now, how do i know for which frecuency i should compensate? i must look at the response graph, don't i? if i place a l-pad to pad down the driver, the high octaves are padded as well? which data of the spec sheet i need to model the drivers in spice?
a last thing... i was looking at your designs... they are excellent but, will they work with my speakers? i mean, are they optimized for one of your designs or it is OK to use them with another speaker?
sorry... something else... it is too difficult wounding a coil myself? i have experience wounding transformers... is this much more difficult? do you know any program that can help me in this task, such as wire gauge, core diameter, number of turns, etc.?

well, thats all for now... thank you very much again!

Matias

• Re: crossover design... help.... - Wayne Parham 16:00:08 04/15/02 (4)
  • Re: crossover design... help.... - Pilkar 05:51:50 04/16/02 (3)
    • Re: crossover design... help.... - Wayne Parham 10:34:40 04/16/02 (2)
      • Re: crossover design... help.... - Pilkar 12:42:25 04/16/02 (1)
        • You have mail! - Wayne Parham 15:54:30 04/16/02 (0)
• did you mean the D205Ti driver? - Sam P. 15:38:42 04/15/02 (1)
  • Re: did you mean the D205Ti driver? - Pilkar 06:11:33 04/16/02 (0)