Posted by Adam on February 15, 2002 at 16:44:05

In Reply to: Re: Wayne, C5 question again... posted by Wayne Parham on February 15, 2002 at 16:02:00:

Thanks Wayne.

It was just a bit of a cost-cutting measurement... The total cost of crossovers on these speakers using the mills resistors is roughly $550 american, plus shipping, plus the rediculous duty charges I usually get slapped with (up to and including 50%) along with the poor exchange rate. I'm simply tapped out of money for these speakers, so finishing the second pair may not happen until the summer.

Thanks for the advice. I'll bite the bullet and go with the poly caps.

Adam

• Re: Wayne, C5 question again... - Adam 16:45:07 02/15/02 (9)
  • complete xover parts and HF stuff was only - Sam P. 08:34:11 02/17/02 (8)
    • Re: complete xover parts and HF stuff was only - Adam 10:15:06 02/17/02 (7)
      • zobels do not require precision - Sam P. 13:39:42 02/17/02 (6)
        • Re: zobels do not require precision - Adam 14:13:26 02/17/02 (5)
          • what about "parts connection" in Ontario?(nt) - Sam P. 15:14:27 02/17/02 (4)
            • new siteis www.partsconnexion.com (nt) - replay 11:22:52 02/18/02 (0)
            • Parts Connection is out of Business I think!?!(nt) - Garland 09:03:52 02/18/02 (0)
            • Re: what about "parts connection" in Ontario?(nt) - Adam 16:24:53 02/17/02 (1)
              • www.partsconnection.on.ca - Sam P. 17:07:08 02/17/02 (0)