Posted by Psychoacoustic [ 61.25.201.1 ] on March 01, 2009 at 23:10:13:

In Reply to: Close, but not the same posted by Wayne Parham on March 01, 2009 at 21:56:37:

Wayne, thanks again for the response and plans. Getting closer to the build... couple more questions.

I understand that this has been done to death, but one more time please...
In Japan, I can only source 10mm ply. The plans call for 20mm (3/4").
For the Pi7 specifically, would gluing two 10mm ply sheets together or one 10mm ply and one 10mm MDF be better, or no difference?

Recently, there was some discussion of crossover value changes. Do you have these updated, populated crossovers ready to go?

PaulW, who has built the Pi7, mentioned enlarging the mid-horn flare dimensions. Any thoughts on this?
Thanks again.

Replies:

• Re: Close, but not the same - Wayne Parham 01:18:14 03/02/09 (8)
  • Re: Close, but not the same - Psychoacoustic 22:14:54 03/04/09 (1)
    • Re: Close, but not the same - Wayne Parham 22:42:14 03/04/09 (0)
  • Oh, my mid-horn mkII idea - PaulW 18:05:27 03/02/09 (5)
    • Re: Oh, my mid-horn mkII idea - Wayne Parham 18:12:39 03/02/09 (4)
      • Re: Oh, my mid-horn mkII idea - PaulW 18:27:39 03/02/09 (3)
        • Front edge trim on midhorn - Wayne Parham 22:27:43 03/02/09 (0)
        • You may now graduate to finger-painting - Psychoacoustic 19:07:47 03/02/09 (1)
          • Re: You may now graduate to finger-painting - PaulW 06:00:40 03/03/09 (0)