Posted by Wayne Parham [ 70.234.126.249 ] on December 17, 2008 at 17:14:58:

In Reply to: Re: 4 Pi baffle cutout question posted by Matts_ on December 17, 2008 at 16:01:02:

The cutout Eminence suggests is too large. We did a few with the Eminence suggested hole size way back when, and it barely left enough edge to put mounting holes through. So I measured the horn and came up with dimensions that would allow flush fit but still had a maximum size lip. It's 9-1/2" x 4-3/4". Eminence should probably update their spec sheet to use this figure, because 10.3 x 4.9 is neither convenient nor useful. It's too big.

Replies: