Posted by Wayne Parham [ 70.234.145.8 ] on October 22, 2008 at 12:22:06:
In Reply to: Target transfer function for 4pi? posted by badman on October 21, 2008 at 19:29:41:
I use a slightly overdamped cabinet for smooth bass rolloff and CD equalization on the tweeter for even power response. The loudspeaker response curve and other performance data is shown at the following link:
If you're just looking for information about the tweeter circuit, the chart below shows the signal presented to the compression driver. It uses a network that provides 6dB/octave augmentation after an initial shelf of flat response. This is the conjugate of the compression driver's power response, and is required when using constant directivity horns.
[ PiSpeakers Forum ] [ Help ]