Posted by Chris R. [ 76.114.34.52 ] on July 20, 2008 at 15:30:28:
Wayne,
I'm close to making up a pair of mid horns, but have a small problem. I need to finished width to be 24", including the outer
box they'll go in. I was reviewing the dimentions from your post 14408 and if I cut both sides and top/bottom to be 4.5" at the
small end, and butt joint them, the horn entrance won't be 4.5" square because of material thickness. In any case, if I need to
narrow the width slightly (~1.5"-2"), should the sides be angled
in to maintain horn length, or just shorten the whole thing a little?
Thx, Chris
[ PiSpeakers Forum ] [ Help ]