Posted by Chris Leger [ 24.54.31.161 ] on September 05, 2006 at 12:43:56:

In Reply to: Re: Meant 2426, not 2126. posted by Wayne Parham on September 05, 2006 at 12:30:19:

Thanks Wayne!

Hmm... I was also thinking that since these cabs would be installed in these spaces as I've described, (and therefore mostly obscured) I could try designing them so they have no parallel surfaces (why, I wouldn't even need to finish anything other than the baffle!) Am I brushing up against the "standing wave" problem you've mentioned? Obviously, given the space available, there is only so much I can do...

Please forgive me for being so clueless. My thinking was that I could construct a box of appropriate dimensions for the drivers chosen, proper length port, etc... but I understand that it's more complex.

Best regards,

Chris Leger

Replies:

• Standing waves inside cabinets - Wayne Parham 15:40:38 09/05/06 (2)
  • Re: Standing waves inside cabinets - Chris Leger 16:16:18 09/05/06 (1)
    • Crossover Information - Wayne Parham 16:38:51 09/05/06 (0)