Posted by Leland Crooks [ 64.254.37.152 ] on July 19, 2006 at 06:38:56:
In Reply to: Re: Heat exchanger effectiveness posted by Wayne Parham on July 18, 2006 at 23:18:19:
I'm pretty sure I did. Been a while since I did this. I did not measure after running the test and heating up the vc however. I do remember that you told me originally that I might have been below the floor of the meter.
I had intended to make some more tests, but I liked the real world results so much that I never bothered. I have am rf thermometer that I intended to put in and read vc temps while running in a cab. There's a gig saturday nite and I'll install it and record during the show. Supposed to be everything from rap to death metal. Last year it was about a 4 hour gig, so it will be a good test bed. At some point I'll try to pull a sink and run without. If I can't I'll do it when I start some new sub cabinets in a week or two, and will be pulling the drivers out anyway. The new boxes will require a redesign of my sinks.
[ PiSpeakers Forum ] [ Help ]