Posted by Wayne Parham [ 68.91.15.161 ] on October 30, 2005 at 19:51:53:

In Reply to: t/s testing on sinks posted by Leland Crooks on October 30, 2005 at 17:18:06:

Good job, very interesting. I think maybe the 1.0v measurements on the HL10A may have been below the sampling floor of the meter, but the higher voltage readings look reasonable. Seems like the situation is reversed on the HL10C, where the low voltage readings look more reliable than the high voltage readings. The current may have increased enough to heat the test resistor and make an impact. I suspect that was probably the case. But all in all, I think you've verified that the cooling plug is not shifting electro-mechanical parameters, so you can expect it to work well for you.

Replies:

• Re: t/s testing on sinks - Leland Crooks 20:12:25 10/30/05 (7)
  • Beta 10 - Leland Crooks 21:45:58 10/30/05 (4)
    • Re: Beta 10 - Leland Crooks 22:51:03 10/30/05 (3)
      • Re: Beta 10 - Wayne Parham 00:13:36 10/31/05 (2)
        • Re: Beta 10 - Leland Crooks 07:11:12 10/31/05 (1)
          • Re: Beta 10 - Wayne Parham 08:31:01 10/31/05 (0)
  • Re: t/s testing on sinks - j.luis cruz 20:33:15 10/30/05 (1)
    • No. - Leland Crooks 21:31:01 10/30/05 (0)