Posted by Bill Epstein [ 24.93.168.146 ] on September 01, 2005 at 16:23:08:
In Reply to: Re: 2 pi speaker terminal idea posted by Shane on September 01, 2005 at 13:22:09:
Get a 3/8 rabbett bit for your router or a dado set for the table saw and make the entire back an access.
Rout or dado 3/8x3/8 rabbets on both the rear panel and the rear opening so one fits into the other, Then apply a single strand of rope caulk all the way around. Screw it down.
Lots of test cuts on scrap until it's just right.
[ PiSpeakers Forum ] [ Help ]