Posted by Kim Schultz [ 62.66.132.40 ] on May 07, 2005 at 03:56:59:

Hi Wayne.

I wanted to make a cad drawing of the midhorn, to get the angles on the sides.
Just bought a new tablesaw, and want to try to minimize the sanding a bit, by cutting the angles on the saw.

But when I make the sides 14.5" long, the top and bottom becomes 11.37" long. And when I make the top and bottom 11" long, the sides become 14.21" long.

Which one is correct, can you tell me the exact depth of the horn, that way I can draw it up using depth instead.

I have included a picture of the two drawings.

Regards
Kim

Replies:

• Re: Another pi midhorn question. - GarMan 09:29:26 05/09/05 (2)
  • Re: Another pi midhorn question. - Kim Schultz 04:22:35 05/13/05 (0)
  • Re: Another pi midhorn question. - Wayne Parham 16:54:43 05/09/05 (0)
• Re: Another pi midhorn question. - Wayne Parham 04:41:28 05/07/05 (4)
  • Re: Another pi midhorn question. - Kim Schultz 05:46:24 05/07/05 (3)
    • Re: Another pi midhorn question. - Wayne Parham 13:52:14 05/07/05 (2)
      • Think I got it now :) - Kim Schultz 16:42:12 05/07/05 (1)
        • Re: Think I got it now :) - Wayne Parham 17:00:52 05/07/05 (0)