Posted by jlharden [ 216.176.88.74 ] on January 04, 2005 at 17:18:09:

In Reply to: Re: Midhorn implementation posted by Wayne Parham on January 03, 2005 at 17:18:38:

Thanks Wayne,

Increasing the mouth size to 14" x 28" yields 392 square inches, very close to the proposed horn you mentioned. 5.5" x 5.5" inch throat is very close to the proposed 30". Am I correct that the radiation angle expanding to the desired mouth size will dictate the horn length? By length, are you refering to the axial length from throat to mouth? Sorry, a little hand holding required. Would the 2012 perform well with this lower cutoff frequency or would the 2206 be better suited. There is a large difference in efficiency between the two units. Thanks, Jerrod

Replies:

• Re: Midhorn implementation - Wayne Parham 17:28:19 01/04/05 (2)
  • Re: Midhorn implementation - Bill Wassilak 16:03:01 01/05/05 (1)
    • Re: Midhorn implementation - Wayne Parham 18:59:24 01/05/05 (0)