In Reply to: Re: Adjusting the capacitor value on the tweeter attenuator posted by Wayne Parham on August 17, 2003 at 12:18:42:
Hey Wayne, what about If I used my ohmmeter to measure the resistances between each resistor to make sure its wired up right?I made a little diagram (I think its right) of the way it looks the attenuator is wired. First we have two 16ohm resistors wired in series with each other. We then have another set of 16ohm resistors wired in series. These two sets are wired in parallel with the tweeter. Then, we have a 20ohm, 30ohm and a .33mfd cap wired in parallel with each other. This set is then wired in series with the tweeter. Is this correct?
Follow Ups: